Normally, micro-duct cables are jetted into an appropriately sized micro-duct. To insure that the jetting operation can be done efficiently, micro-duct should be selected to have some space between its inner diameter (ID) and the cable it contains.

Today FCST brings you a disruptive product, SMC Telecom Manhole Chamber.SMC Telecom Manhole Chamber System is to protect and connect your fiber netwroks. SMC Telecom Manhole Chamber System is manufactured of innovated fiberglass reinforced composite material, with advantages of strong, lightweight and corrosion-resistance.

SMC Telecom Manhole Chamber system is design for cable underground network access, with internal room to storage slack cable or splicing closures. Inside the walls,brackets for holding above parts are reserved which can easily set up on site. Flat walls enable any futuer flexible decoration by drilling self-tapping screws.

With the popularization of the Underground Cable Installation Solution, the construction of the basic network architecture has been accelerated. But there will be some problems during construction. For example, the resistance of Air Blowing Micro Cable in Microduct is a bit large.

Before the cable placing operation begins, the microduct system should be checked to be assured the cable’s minimum bend radius is not violated during handling, feeding, placing, and final positioning. The equipment and all pressure fittings should be checked.

There are primarily four ways to install direct buried microducts: l Using a machine or hand to excavate an area and install them directly into the ground. l Placing it into a slot-cut or micro trench. l Using a mole plow. l Integrating it into an existing duct. Before you begin any of these installations, you will want to use a manufacturer-supplied tube cutter to cut the microduct. Do not use any other cutting tool. Next, you need to make sure a sealing plug covers both ends of the microduct. Putting this in place will prevent any water or dirt from contaminating the duct and possibly causing damage. Finally, you want to check to see if you've trapped the drawcord with the sealing plug.