Related Products

Share to:

14/10mm HDPE Microduct

Test	Characteristic		Test Method		Acceptance Criteria
Raw Materials
1	Bundles is manufactured with 100% virgin HDPE
		2	Melt flow index	ASTM 1238 190℃ @ 2.16KG Load		≤ 0.40 g/10min
		3	Density	ASTM D792		0.940～0.958 g/cm³
		4	Environmental stress crack resist (F50)	ISO 4599		Min. 96h
Physical and Mechanical Properties – Inner Micro duct 14/10mm
1	Visual appearance		Visual inspection		Ribbed inside & smooth outside surface, free from blisters, shrink hole, flaking, scratches & roughness.
2	Outer diameter		FCST		14.0mm ± 0.1mm
3	Wall thickness		FCST		2.00mm ± 0.10mm
4	Inner diameter clearance		Blowing steel ball		A 8.5mm steel ball can be blown freely through the duct.
5	Ovality		FCST		≤ 5%
6	Pressurization		5 minutes @25bar each duct		No damage and leakage
7	Kink		IEC 60794-1-2 Method E10		≤ 140mm
8	Tensile strength		Rate of extension: 100mm/min		≥ 1350N
9	Crush		Sample length: 250mm Load: 1400N Duration of Max. load: 1 min Recovery time: 1 hour		No residual deformation > 15% of inner and outer diameter, shall pass inner diameter clearance test.
10	Impact		IEC 60794-1-2 Method E4 1.5J Impact, recovery time 1 hour		No residual deformation > 15% of inner and outer diameter, shall pass inner diameter clearance test.
11	Heat reversion		110℃ ～ 23℃, 1 hour		≤ 3%
12	Min. bend radius		168mm		No residual deformation > 15% of inner and outer diameter, shall pass inner diameter clearance test.
13	Co-efficient of Friction		750mm Diameter, 450°loop, 5kg mass		≤ 0.1
14	Color and printing		Visual inspection		As per customer specification

Test	Characteristic	Test Method	Acceptance Criteria
Physical and Mechanical Properties – tube bundles
1	Visual appearance	Visual inspection, Outer sheath: Black	Ribbed inside & smooth outside surface, free from blisters, shrink hole, flaking, scratches & roughness.
2	Outer diameter	FCST	16.4mm (± 0.5mm)
3	Sheath Wall thickness	FCST	1.20mm ± 0.20mm
4	Pressurization	5 minutes @25bar each duct	No damage and leakage
5	Tensile strength	Rate of extension: 100mm/min	≥ 1200N
6	Crush	Sample length: 250mm Load: 1000N Duration of Max. load: 1 min Recovery time: 1 hour	No residual deformation > 15% of inner and outer diameter, shall pass inner diameter clearance test.
7	Impact	IEC 60794-1-2 Method E4 1.5J Impact, recovery time 1 hour	No residual deformation > 15% of inner and outer diameter, shall pass inner diameter clearance test.
8	Min. bend radius	280mm	No residual deformation > 15% of inner and outer diameter, shall pass inner diameter clearance test.
9	Color and printing	Visual inspection	Orange or as per customer specification

Completed packages of the HDPE micro duct on drum can be stored outdoor max. 6 months upon the date of production.

Storage temperature: -40°C ～ +70°C

Installation temperature: -30°C ～ +50°C

Operating temperature: -40°C ～ +70°C